Filter
Top Products
a. Select the media type using the or keys.
b. Press the OK key to confirm the selection.
18. Select whether or not a liner is used.
a. Select liner use requirement using the or keys. If a liner is used (Refer to Double sided
printing with a liner).
b. Press the OK key to confirm the selection.
19. At the rear of the printer, use the black media advance switch to loosen the media enough to be able
to install a tension bar (1) of approximately half the media width in the slack area of the media.
NOTE If the media is difficult to unwind from the take-up reel, increase the length of the
tension bar in order to apply more pressure.
20. The media setting operation starts automatically.
NOTE If the media adheres to the platen, set the VACUUM to low.
Verify the front panel shows this message and press the OK key.
ENWW Printing on the back of the media from the take-up reel (without relocating from take-
up side)
151
How do I perform double-sided
p
rintin
g