Filter
Top Products
Configuring and managing IP interfaces and services 135
Nortel WLAN—Security Switch 2300 Series Configuration Guide
Displaying HTTPS information
To display HTTPS service information, use the following command:
show ip https
To display information for a WSS’s HTTPS server, type the following command:
WSS> show ip https
HTTPS is enabled
HTTPS is set to use port 443
Last 10 Connections:
IP Address Last Connected Time Ago (s)
------------ ----------------------- ------------
10.10.10.56 2003/05/09 15:51:26 pst 349
The command lists the TCP port number on which the switch listens for HTTPS connections. The command also lists
the last 10 devices to establish HTTPS connections with the switch and when the connections were established.
If a browser connects to a WSS from behind a proxy, then only the proxy IP address is shown. If multiple browsers
connect using the same proxy, the proxy address appears only once in the output.
Changing the idle timeout for CLI management sessions
By default, WSS Software automatically terminates a console or Telnet session that is idle for more than one hour. To
change the idle timeout for CLI management sessions, use the following command:
set system idle-timeout seconds
You can specify from 0 to 86400 seconds (one day). The default is 3600 (one hour). If you specify 0, the idle timeout is
disabled. The timeout interval is in 30-second increments. For example, the interval can be 0, or 30 seconds, or 60
seconds, or 90 seconds, and so on. If you enter an interval that is not divisible by 30, the CLI rounds up to the next
30-second increment. For example, if you enter 31, the CLI rounds up to 60.
This command applies to all types of CLI management sessions: console, Telnet, and SSH. The timeout change applies
to existing sessions only, not to new sessions.
The following command sets the idle timeout to 1800 seconds (one half hour):
WSS# set system idle-timeout 1800
success: change accepted.
To reset the idle timeout to its default value, use the following command:
clear system idle-timeout
To display the current setting (if the timeout has been changed from the default), use the show config area system
command. If you are not certain whether the timeout has been changed, use the show config all command.