Filter
Top Products
92 Configuring and managing ports and VLANs
NN47250-500 (320657-F Version 02.01)
Configuring for a AP
To configure a connection for a AP (referred to as a AP in the CLI), use the following command:
set ap ap-num serial-id serial-ID
model {2330 | 2330A | 2330B | 2332-A1 | 2332-A2 | 2332-A3 | 2332-A4 | 2332-A5 |
2332-A6 | 2332-E1 | 2332-E2 | 2332-E3 | 2332-E4 | 2332-E5 |2332-E6 | 2332-E7 |
2332-E8 | 2332-E9 | 2332-J1}
[radiotype {11a | 11b| 11g}]
The ap-num parameter identifies the AP connection for the AP. The range of valid connection ID numbers
depends on the WSS model. Table 3 lists the ranges of valid ap-num values for each model.
For the serial-id parameter, specify the serial ID of the AP. The serial ID is listed on the AP case. To display
the serial ID using the CLI, use the show version details command.
The model and radiotype parameters have the same options as they do with the set port type ap command.
Because the WSS does not supply power to an indirectly connected AP, the set ap command does not use the
poe parameter.
To configure AP connection 1 for AP model 2330 with serial-ID 0322199999, type the following command:
WSS# set ap 1 serial-id 0322199999 model 2330
success: change accepted.
Setting a port for a wired authentication user
To set a port for a wired authentication user, use the following command:
set port type wired-auth port-list [tag tag-list] [max-sessions num]
[auth-fall-thru {last-resort | none | web-portal}]
You must specify a port list. Optionally, you also can specify a tag-list to subdivide the port into virtual ports,
set the maximum number of simultaneous user sessions that can be active on the port, and change the fallthru
authentication type.
By default, one user session can be active on the port at a time.
The fallthru authentication type is used if the user does not support 802.1X and is not authenticated by MAC
authentication. The default is none, which means the user is automatically denied access if neither 802.1X
authentication or MAC authentication is successful.
Table 3: Valid ap-num Values
Switch Model Valid Range
2382 1 to 320
2380 1 to 300
2360/2361 1 to 30
2350 1 to 8