Filter
Top Products
Configuring APs 221
Nortel WLAN—Security Switch 2300 Series Configuration Guide
beacon enable Sends beacons to advertise the SSID
managed by the service profile.
cac-mode none Does not limit the number of active user
sessions based on Call Admission Control
(CAC).
cac-session 14 If session-based CAC is enabled
(cac-mode is set to session), limits the
number of active user sessions on a radio
to 14.
cipher-ccmp disable Does not use Counter with Cipher Block
Chaining Message Authentication Code
Protocol (CCMP) to encrypt traffic sent to
WPA clients.
cipher-tkip enable When the WPA IE is enabled, uses
Temporal Key Integrity Protocol (TKIP)
to encrypt traffic sent to WPA clients.
cipher-wep104 disable Does not use Wired Equivalent Privacy
(WEP) with 104-bit keys to encrypt traffic
sent to WPA clients.
cipher-wep40 disable Does not use WEP with 40-bit keys to
encrypt traffic sent to WPA clients.
cos 0 If static CoS is enabled (static-cos is set to
enable), assigns CoS 0 to all data traffic to
or from clients.
dhcp-restrict disable Does not restrict a client’s traffic to only
DHCP traffic while the client is being
authenticated and authorized.
idle-client-probing enable Sends a keepalive packet (a null-data
frame) to each client every 10 seconds.
keep-initial-vlan disable Reassigns the user to a VLAN after
roaming, instead of leaving the roamed
user on the VLAN assigned by the switch
where the user logged on.
Note: Enabling this option does not retain
the user’s initial VLAN assignment in all
cases.
long-retry-count 5 Sends a long unicast frame up to five
times without acknowledgment.
Table 2: Defaults for service profile parameters (continued)
Parameter Default Value
Radio Behavior When Parameter Set
To Default Value