Configuring APs 273
Nortel WLAN—Security Switch 2300 Series Configuration Guide
Displaying AP information
You can display the following AP information:
• AP and radio-specific configuration settings
• Connection information for Distributed APs configured on a WSS
• List of Distributed APs that are not configured on a WSS
• Connection information for Distributed APs
• Service profile information
• Radio profile information
• Status information
• Information about static IP addresses on Distributed APs
• Statistics counters
Displaying AP configuration information
To display configuration information, use the following commands:
show ap config [port-list [radio {1 | 2}]]
show ap config [ap-num [radio {1 | 2}]]
The command lists information separately for each AP.
To display configuration information for an AP on WSS port 2, type the following command:
WSS# show ap config 2
Port 2: AP model: 2330, POE: enable, bias: high, name: MP02
boot-download-enable: YES
force-image-download: YES
Radio 1: type: 802.11g, mode: disabled, channel: 6
tx pwr: 1, profile: default
auto-tune max-power: default
Radio 2: type: 802.11a, mode: disabled, channel: 36
tx pwr: 1, profile: default
auto-tune max-power: default
To display configuration information for a AP configured on connection 1, type the following command:
WSS# show ap config 1
ap 1: serial-id: 12345678, AP model: 2330, bias: high, name: ap01
fingerprint: b4:f9:2a:52:37:58:f4:d0:10:75:43:2f:45:c9:52:c3
boot-download-enable: YES
force-image-download: YES
Radio 1: type: 802.11g, mode: disabled, channel: 6
tx pwr: 1, profile: default
auto-tune max-power: default
Radio 2: type: 802.11a, mode: disabled, channel: 36
tx pwr: 1, profile: default
auto-tune max-power: default