Filter
Top Products
Configuring network domains 191
Nortel WLAN—Security Switch 2300 Series Configuration Guide
Clearing network domain seed or member configuration from a WSS
You can remove the Network Domain seed or member configuration from the WSS. To do this, enter the following
command:
clear network-domain mode {seed | member}
Use the seed parameter to clear Network Domain seed configuration from the WSS. Use the member parameter to clear
Network Domain member configuration from the WSS.
Network domain scenario
The following scenario illustrates how to create a Network Domain named globaldom consisting of three Mobility
Domains at two geographically separated sites. Figure 4 below illustrates this scenario.
Figure 4. Network domain scenario
In this scenario, there are three Mobility Domains: A, B, and C. Mobility Domain A is located at Site 1, and Mobility
Domains B and C are located at Site 2. There are two Network Domain seeds, one at each site, that share information
WAN Link
Mobility Domain A
Net. Domain Seed 2
Mob. Domain B Member
Mobility Domain C
Layer 2-3
Layer 2-3
Mobility Domain B
Mob. Domain B
Seed
Mob. Domain B
Member
Mob. Domain C
Seed
Mob. Domain C
Member
Site 1
Site 2
20.20.20.1
20.20.20.2 20.20.20.3
30.30.30.1 30.30.30.2
20.20.20.2
Net. Domain Seed 1
Mob. Domain A Seed
Layer 2-3
Mob. Domain A
Member
Mob. Domain A
Member
10.10.10.1
10.10.10.310.10.10.2