Nortel Networks 2300 Switch User Manual


 
Configuring network domains 181
Nortel WLAN—Security Switch 2300 Series Configuration Guide
Figure 2. How a user connects to a remote VLAN in a network domain
In this example, Bob establishes connectivity as follows:
1 Bob connects to the wireless network at the Corporate Office. The WSS contacts the local Mobility
Domain seed and finds that the VLAN that Bob is configured to be on, VLAN Red, does not exist in the
Corporate Office Mobility Domain.
2 Unable to find VLAN Red in the local Mobility Domain, the WSS then contacts the local Network
Domain seed. The Network Domain seed contains a database of all the VLANs configured on all the
members of the Network Domain. (The Network Domain seed may or may not be the same WSS as the
Mobility Domain seed.)
3 The Network Domain seed looks in its database and finds that VLAN Red exists in the Mobility Domain
at Sales Office C. The Network Domain seed then responds with the IP address of the remote WSS where
VLAN Red is configured.
4 A VLAN tunnel is created between the WSS at the Corporate Office and the WSS at Sales Office C.
5 Bob establishes connectivity on the network at the corporate office and is placed in VLAN Red.
Layer 2-3
Layer 2-3 Layer 2-3
Corporate Office
Bob
ND Seed
Peer
ND Seed
Peer
ND Seed
Peer
ND Seed
Peer
ND Seed
Peer
ND Seed
Peer
VLAN Red
Configured
WAN Link
User Bob connects
to WSS at
Corporate Office
1
WSS
queries ND Seed
about VLAN Red
2
ND Seed replies
pointing to WSS at Sales Office
3
Tunnel is created between
WSS at Corporate Office
and WSS at Sales Office
4
User Bob
is connected
on VLAN Red
5
Sales Office A Sales Office B Sales Office C
Branch Office 2Branch Office 1