Filter
Top Products
682 Appendix A:Troubleshooting a WSS
NN47250-500 (320657-F Version 02.01)
Clearing the trace log
To clear all messages from the trace log buffer, type the following command:
WSS# clear log trace
List of trace areas
To see all WSS Software areas you can trace, type the following command:
WSS# set trace?
Using show commands
To troubleshoot the WSS, you can use show commands to display information about different areas of the WSS
Software. The following commands can provide helpful information if you are experiencing WSS Software performance
issues.
Viewing VLAN interfaces
To view interface information for VLANs, type the following command:
WSS# show interface
* = From DHCP
VLAN Name Address Mask Enabled State RIB
--------------- ---------------- ------------------ ---------- -------- --------
1 default 0.0.0.0 0.0.0.0 NO Down ipv4
130 vlan-eng 192.168.12.7 255.255.255.0 YES Up ipv4
190 vlan-wep 192.168.19.7 255.255.255.0 YES Up ipv4
(For more information about VLAN interfaces, see “Configuring and managing VLANs” (page 103).)
Viewing AAA session statistics
To view AAA session statistics, type the following command:
WSS# show aaa
Default Values
authport=1812 acctport=1813 timeout=5 acct-timeout=5
retrans=3 deadtime=5 key=(null) author-pass=(null)
Radius Servers
Server Addr Ports T/o Tries Dead State
-------------------------------------------------------------------
SQA2BServer 11.1.1.11 1812 1813 5 3 5 UP
SideShow 192.168.0.21 1812 1813 5 3 0 UP
Server groups
sg1: SideShow