312 Configuring user encryption
NN47250-500 (320657-F Version 02.01)
Assigning static WEP keys
When static WEP is enabled, static WEP key 1 is assigned to unicast and multicast traffic by default. To assign
another key to unicast or multicast traffic, use the following commands:
set service-profile name wep active-multicast-index num
set service-profile name wep active-unicast-index num
The num parameter specifies the key and the value can be from 1 to 4.
To configure an SSID that uses service profile wepsrvc to use WEP key index 2 for encrypting multicast
traffic, type the following command:
WSS# set service-profile wepsrvc wep active-multicast-index 2
success: change accepted.
To configure an SSID that uses service profile wepsrvc4 to use WEP key index 4 for encrypting unicast traffic,
type the following command:
WSS# set service-profile wepsrvc4 wep active-unicast-index 4
success: change accepted.
Encryption configuration scenarios
The following scenarios provide examples of ways in which you can configure encryption for network clients:
• “Enabling WPA with TKIP” (page 313)
• “Enabling dynamic WEP in a WPA network” (page 315)
• “Configuring encryption for MAC clients” (page 317)