Filter
Top Products
234 Configuring APs
NN47250-500 (320657-F Version 02.01)
Enabling the auto-AP profile
To enable the Auto-AP profile for automatic Distributed AP configuration, type the following command:
WSS# set ap auto mode enable
success: change accepted.
Specifying the radio profile used by the auto-AP profile
The Auto-AP profile uses radio profile default by default. To use another radio profile instead, use the
following command:
set ap auto radio {1 | 2} radio-profile name mode {enable | disable}
The following command changes the Auto-AP profile to use radio profile autoap1 for radio 1:
WSS# set ap auto radio 1 radio-profile autoap1
success: change accepted.
Displaying status information for APs configured by the auto-AP profile
To display status information for APs configured by the Auto-AP profile, type the following command:
WSS# show ap status auto
ap: 100 (auto), IP-addr: 10.8.255.6 (vlan 'default'), AP model: 2330,
manufacturer: Nortel, name: ap100
====================================================
State: operational (not encrypted)
CPU info: IBM:PPC speed=266666664 Hz version=405GPr
id= ram=33554432
s/n=0333703027 hw_rev=A3
Uptime: 18 hours, 36 minutes, 27 seconds
Radio 1 type: 802.11g, state: configure succeed [Enabled] (802.11b protect)
operational channel: 1 operational power: 14
base mac: 00:0b:0e:00:d2:c0
bssid1: 00:0b:0e:00:d2:c0, ssid: public
bssid2: 00:0b:0e:00:d2:c2, ssid: employee-net
bssid3: 00:0b:0e:00:d2:c4, ssid: mycorp-tkip
Radio 2 type: 802.11a, state: configure succeed [Enabled]
operational channel: 64 operational power: 14
base mac: 00:0b:0e:00:d2:c1
bssid1: 00:0b:0e:00:d2:c1, ssid: public
bssid2: 00:0b:0e:00:d2:c3, ssid: employee-net
bssid3: 00:0b:0e:00:d2:c5, ssid: mycorp-tkip
The output displays auto next to the Distributed AP number to indicate that the AP was configured using an
Auto-AP profile.
Note. You must configure the radio profile before you can apply it to the Auto-AP profile.