Filter
Top Products
326 Configuring Auto-RF
NN47250-500 (320657-F Version 02.01)
Changing power tuning settings
Enabling power tuning
Auto-RF for power is disabled by default. To enable or disable the feature for all radios in a radio profile, use
the following command:
set radio-profile name auto-tune power-config {enable | disable}
To enable power tuning for radios in the rp2 radio profile, type the following command:
WSS# set radio-profile rp2 auto-tune power-config enable
success: change accepted.
Changing the power tuning interval
The default power tuning interval is 300 seconds. You can change the interval to a value from 1 to 65535
seconds. To change the power tuning interval, use the following command:
set radio-profile name auto-tune power-interval seconds
To set the power tuning interval for radios in radio profile rp2 to 240 seconds, type the following command:
WSS# set radio-profile rp2 auto-tune power-interval 240
success: change accepted.
Changing the maximum default power allowed on a radio
By default, the maximum power level that Auto-RF can set on a radio is the same as the maximum power level
allowed for the country of operation. To change the maximum power level that Auto-RF can assign, use the
following command:
set {ap port-list | ap ap-num} radio {1 | 2} auto-tune max-power power-level
The power-level can be a value from 1 to 20.
To set the maximum power that Auto-RF can set on radio 1 on the AP on port 7 to 12 dBm, type the following
command.
WSS# set ap 7 radio 1 auto-tune max-power 12