Filter
Top Products
Configuring APs 275
Nortel WLAN—Security Switch 2300 Series Configuration Guide
WSS# show ap unconfigured
Total number of entries: 2
Serial Id Model IP Address Port Vlan
----------- ------ --------------- ---- --------
0333001287 2330 10.3.8.54 5 default
0333001285 2330 10.3.8.57 7 vlan-eng
Displaying active connection information for APs
A AP can have only one active data connection. To display the system IP address of the WSS that has the active connec-
tion (the switch that booted the AP), use the following command:
show ap connection [ap-num | serial-id serial-ID]
The serial-id parameter displays the active connection for a Distributed AP even if that AP is not configured on this
WSS. However, if you use the command with the ap-num parameter or without a parameter, connection information is
displayed only for APs that are configured on this WSS.
This command provides information only if the AP is configured on the switch where you use the command. The switch
does not need to be the one that booted the AP, but it must have the AP in its configuration. Also, the switch that booted
the AP must be in the same Mobility Domain as the switch where you use the command.
Displaying service profile information
To display service profile information, use the following command:
show service-profile {name | ?}
Entering show service-profile ? displays a list of the service profiles configured on the switch.
To display information for service profile sp1, type the following command:
WSS# show service-profile sp1
ssid-name: corp2 ssid-type: crypto
Beacon: yes Proxy ARP: no
DHCP restrict: no No broadcast: no
Short retry limit: 5 Long retry limit: 5
Auth fallthru: none Sygate On-Demand (SODA): no
Enforce SODA checks: yes SODA remediation ACL:
Custom success web-page: Custom failure web-page:
Custom logout web-page: Custom agent-directory:
Static COS: no COS: 0
CAC mode: none CAC sessions: 14
User idle timeout: 180 Idle client probing: yes
Keep initial vlan: no Web Portal Session Timeout: 5
Web Portal ACL:
WEP Key 1 value: <none> WEP Key 2 value: <none>
WEP Key 3 value: <none> WEP Key 4 value: <none>
WEP Unicast Index: 1 WEP Multicast Index: 1
Shared Key Auth: NO
WPA enabled:
ciphers: cipher-tkip
authentication: 802.1X
TKIP countermeasures time: 60000ms