Filter
Top Products
232 Configuring APs
NN47250-500 (320657-F Version 02.01)
Configuring an auto-AP profile
The Auto-AP profile for Distributed AP configuration is like an individual AP configuration, except the
configuration has the name auto instead of a Distributed AP number.
To create an Auto-AP profile for automatic Distributed AP configuration, type the following command:
WSS# set ap auto
success: change accepted.
To display the AP settings in the Auto-AP profile, type the following command:
WSS# show ap config auto
AP auto: mode: disabled bias: high
fingerprint
boot-download-enable: YES
force-image-download: NO
Radio 1: type: 802.11g, mode: enabled, channel: dynamic
tx pwr: 15, profile: default
auto-tune max-power: default
Radio 2: type: 802.11a, mode: enabled, channel: dynamic
tx pwr: 11, profile: default
auto-tune max-power: default
This example shows the defaults for the AP parameters you can configure in the Auto-AP profile. Table 7 lists
the configurable Auto-AP profile parameters and their defaults. The only parameter that requires configuration
is the Auto-AP profile mode. The Auto-AP profile is disabled by default. To use the Auto-AP profile to
configure Distributed APs, you must enable the profile. (See “Enabling the auto-AP profile” (page 234).)
Table 7: Configurable profile parameters for distributed APs
Parameter Default Value
AP Parameters
bias high
blink
(Not shown in show ap config
output)
disable
force-image-download disable (NO)
group (load balancing group) none
mode disabled
persistent none
upgrade-firmware
(boot-download-enable)
enable (YES)
Radio Parameters