94 Configuring and managing ports and VLANs
NN47250-500 (320657-F Version 02.01)
To clear a port, use the following command:
clear port type port-list
For example, to clear the port-related settings from port 5 and reset the port as a network port, type the
following command:
WSS# clear port type 5
This may disrupt currently authenticated users. Are you sure? (y/n) [n]y
success: change accepted.
Clearing a AP
To clear a AP, use the following command:
clear ap ap-num
Configuring a port name
Each WSS port has a number but does not have a name by default.
Setting a port name
To set a port name, use the following command:
set port port name name
You can specify only a single port number with the command.
To set the name of port 14 to adminpool, type the following command:
WSS# set port 14 name adminpool
success: change accepted.
Caution! When you clear a AP, WSS Software ends user sessions that are using the
AP.
Note. To avoid confusion, Nortel recommends that you do not use numbers as port
names.