Filter
Top Products
226 Configuring APs
NN47250-500 (320657-F Version 02.01)
Table 4: Defaults for radio profile parameters
Parameter Default Value
Radio Behavior When Parameter
Set To Default Value
active-scan enable Sends probe any requests (probe requests
with a null SSID name) to solicit probe
responses from other access points.
(See “Rogue detection and counter
measures” (page 625).)
beacon-interval 100 Waits 100 ms between beacons.
countermeasures Not configured Does not issue countermeasures against
any device.
(See “Rogue detection and counter
measures” (page 625).)
dtim-interval 1 Sends the delivery traffic indication map
(DTIM) after every beacon.
frag-threshold 2346 Uses the short-retry-count for frames
shorter than 2346 bytes and uses the
long-retry-count for frames that are
2346 bytes or longer.
max-rx-lifetime 2000 Allows a received frame to stay in the
buffer for up to 2000 ms (2 seconds).
max-tx-lifetime 2000 Allows a frame that is scheduled for
transmission to stay in the buffer for up to
2000 ms (2 seconds).
preamble-length short Advertises support for short 802.11b
preambles, accepts either short or long
802.11b preambles, and generates unicast
frames with the preamble length specified
by the client.
Note: This parameter applies only to
802.11b/g radios.
qos-mode wmm Classifies and marks traffic based on
802.1p and DSCP, and optimizes
forwarding prioritization of AP radios for
Wi-Fi Multimedia (WMM).
rfid-mode disable Radio does not function as a location
receiver in an AeroScout Visibility
System.