Configuring SNMP 163
Nortel WLAN—Security Switch 2300 Series Configuration Guide
Enabling the SNMP service
To enable the WSS Software SNMP service, use the following command:
set ip snmp server {enable | disable}
The following command enables the SNMP service:
WSS# set ip snmp server enable
success: change accepted.
Displaying SNMP information
You can display the following SNMP information:
• Version and status information
• Configured community strings
• User-based security model (USM) settings
• Notification targets
• SNMP statistics counters
Displaying SNMP version and status information
To display SNMP version and status information, use the following command:
show snmp status
Displaying the configured SNMP community strings
To display the configured SNMP community strings, use the following command:
show snmp community
Displaying USM settings
To display USM settings, use the following command:
show snmp usm
Displaying notification profiles
To display notification profiles, use the following command:
show snmp notify profile