Filter
Top Products
272 Configuring APs
NN47250-500 (320657-F Version 02.01)
The following command enables all radios that use radio profile rp1:
WSS# set radio-profile rp1 mode enable
success: change accepted.
The following commands disable all radios that use radio profile rp1, change the beacon interval, then reenable the
radios:
WSS# set radio-profile rp1 mode disable
success: change accepted.
WSS# set radio-profile rp1 beacon-interval 200
success: change accepted.
WSS# set radio-profile rp1 mode enable
success: change accepted.
Resetting a radio to its factory default settings
To disable an AP radio and reset it to its factory default settings, use the following command:
clear {ap port-list | ap ap-num} radio {1 | 2 | all}
This command performs the following actions:
• Sets the transmit power, channel, and external antenna type to their default values.
• Removes the radio from its radio profile and places the radio in the default radio profile.
This command does not affect the PoE setting.
To disable and reset radio 2 on the AP connected to port 3, type the following command:
WSS# clear ap 3 radio 2
Restarting an AP
To restart an AP, use the following command:
reset {ap port-list | ap ap-num}
Use the reset ap command to reset an AP configured on an AP access port. Use the reset ap command to reset a AP.
When you enter one of these commands, the AP drops all sessions and reboots.
Caution! Restarting an AP can cause data loss for users who are currently associated
with the AP.