Filter
Top Products
WSS setup methods 59
Nortel WLAN—Security Switch 2300 Series Configuration Guide
Web Quick Start (2350 and 2360/2361)
You can use the Web Quick Start to configure the switch to provide wireless access to up to ten network users.
To access the Web Quick Start, attach a PC directly to port 1 or port 2 on the switch and use a web browser on the PC to
access IP address 192.168.100.1. (For more detailed instructions, see “Accessing the Web Quick Start” (page 60).)
Web Quick Start parameters
The Web Quick Start enables you to configure basic wireless access for a small office. You can use the Web Quick Start
to configure the following parameters:
• System name of the switch
• Country code (the country where wireless access will be provided)
• Administrator username and password
• Management IP address and default router (gateway)
• Time and date (statically configured or provided by an NTP server)
• Management access
You can individually select Telnet, SSH, and Web View. You also can secure the Console port. Access
requires the administrator username and password.
• Power over Ethernet (PoE), for ports directly connected to APs
• SSIDs and authentication types. The Web Quick Start enables you to configure one secure SSID and one clear
SSID. You can configure additional SSIDs using the CLI or WLAN Management Software.
• Usernames and passwords for your wireless users. You can configure up to ten users with the Web Quick Start. To
configure additional users, use the CLI or WLAN Management Software.
Web Quick Start requirements
To use the Web Quick Start, you need the following:
• AC power source for the switch
• PC with an Ethernet port that you can connect directly to the switch
Note. The Web Quick Start application is different from Web View. Web View is a
web-based management application that is available at any time on a switch that already
has IP connectivity. (Web View access also requires the switch’s HTTPS server to be
enabled.) The Web Quick Start application is accessible only on unconfigured switches.
Note. The Web Quick Start application is supported only on switch models 2350 and
2360/2361. After you finish the Web Quick Start, it will not be available again unless you
clear (erase) the switch’s configuration.