Filter
Top Products
270 Configuring APs
NN47250-500 (320657-F Version 02.01)
Specifying the external antenna model
To specify the 2.4 GHz external antenna model, use the following command:
set {ap port-list | ap ap-num} radio {1 | 2} antennatype {internal | 24143 | 24123 | 24113
| 24203 | 24403 | 24453 | 24493 | 24553 | 24883 | mixed | 24143-OUT |
24143-OUT-10 | 24143-OUT-25 | 24143-NEMA | 24143-NEMA-10 |
24143-NEMA-25 | 24123-OUT | 24123-OUT-10 | 24123-OUT-25 | 24123-NEMA |
24123-NEMA-10 | 24123-NEMA-25 | 24113-OUT | 24113-OUT-10 |
24113-OUT-25 | 24113-NEMA | 24113-NEMA-10 | 24113-NEMA-25 | 24493-OUT
| 24493-OUT-10 | 24493-OUT-25 | 24493-NEMA | 24493-NEMA-10 |
24493-NEMA-25 | 24883-OUT | 24883-OUT-10 | 24883-OUT-25 | 24883-NEMA |
24883-NEMA-10 | 24883-NEMA-25}
To specify the 5.0 GHz external antenna model, use the following command:
set {ap port-list | ap ap-num} radio {1 | 2} antennatype {internal | 5303 | 5643 | 5133 |
5173 | 5103 | mixed | 5133-OUT | 5133-OUT-10 | 5133-OUT-25 | 5133-NEMA |
5133-NEMA-10 | 5133-NEMA-25 | 5643-OUT | 5643-OUT-10 | 5643-OUT-25 |
5643-NEMA | 5643-NEMA-10 | 5643-NEMA-25}
To configure antenna model 5303 for a 2330/2330A/2330B on AP 1, type the following command:
WSS# set ap 1 radio 1 antennatype 5303
success: change accepted.
Mapping the radio profile to service profiles
To assign SSIDs to radios, you must map the service profiles for the SSIDs to the radio profile that is assigned
to the radios.
To map a radio profile to a service profile, use the following command:
set radio-profile name service-profile name
The following command maps service-profile wpa_clients to radio profile rp2:
WSS# set radio-profile rp2 service-profile wpa_clients
success: change accepted.
Note. The options displayed are dependent upon the access point model number that
this command is executed against.