Filter
Top Products
660 Managing system files
NN47250-500 (320657-F Version 02.01)
set ip dns server 10.20.10.69 SECONDARY
set ip route default 10.8.1.1 1
set log console disable severity debug
set log session disable severity alert
set log buffer enable severity error messages 200
set log trace disable severity error mbytes 10
set log server 192.168.253.11 severity critical
set timezone PST -8 0
set summertime PDT start first sun apr 2 0 end last sun oct 2 0
set system name WSS
set system countrycode US
set system contact nortel-pubs
set radius server r1 address 192.168.253.1 key sunflower
set server group sg1 members r1
set enablepass password b6b706525e1814394621eeb2a1c4d5803fcf
set authentication console * none
set authentication admin * none
set user tech password encrypted 1315021018
press any key to continue, q to quit.
To display only the VLAN configuration commands, type the following command:
WSS# show config area vlan
# Configuration nvgen'd at 2004-5-10 19:08:38
# Image 2.1.0
# Model WSS
# Last change occurred at 2004-5-10 16:31:14
set vlan 1 port 1
set vlan 10 name backbone tunnel-affinity 5
set vlan 10 port 21
set vlan 10 port 22
set vlan 3 name red tunnel-affinity 5
set igmp mrsol mrsi 60 vlan 1
set igmp mrsol mrsi 60 vlan 10
Saving configuration changes
To save the running configuration to a configuration file, use the following command:
save config [filename]
If you do not specify a filename of up to 128 alphanumeric characters, the command replaces the startup
configuration file that was loaded the last time the software was rebooted. (To display the filename of that
configuration file, see “Displaying boot information” (page 653).)