Filter
Top Products
Monitoring and Configuring the Printer
270
6
DHCP server not found. The DHCP server was not found. Make sure
that the DHCP is on the network.
dhcpcd start. The DHCPCD service (dhcp client service) has
started.
dpsd is disabled. Communication via PictBridge is unavailable
because PictBridge is disabled in the security
mode. Enable PictBridge in the security mode.
Duplicate IP=<IP address>(from<MAC ad-
dress>).
The same IP address (IPv4, or IPv6 address)
was used. Each IP address (IPv4, or IPv6 ad-
dress) must be unique. Check the address of
the device indicated in [MAC address].
Established SPX Connection with PServer,
(RPSocket=<socketnumber>, connID=<con-
nection ID>)
(In the remote printer mode) Connection to the
print server has been established.
exiting The lpd service has ended and the system is
exiting the process.
Exit pserver (In the print server mode) The print server
function is disabled because the necessary
print server settings have not been made.
Frametype =<frame typename> The frame type name is configured to be used
on NetWare.
httpd start. The httpd service has started.
IEEE 802.11b <communication mode> mode Displays IEEE 802.11b communication mode.
inetd start. The inetd service has started.
Interface (interface name): Duplicate IP Ad-
dress (IP address).
The same IP (IPv4 or IPv6) address was used.
Each IP address must be unique. Check the ad-
dress of the device indicated in [IP address].
< Interface > started with IP: < IP address > IP address (IPv4, or IPv4 address) has been set
for the interface and is operating.
< Interface >: Subnet overlap. The same IP address (IPv, orIPv6 address) and
the subnet mask is used with other device.
IPP cancel-job: permission denied. The printer could not authenticate the name of
the user attempting to cancel a job.
IPP job canceled. jobid=%d. The spooled job was canceled due to error or
user request.
LeaseTime=<lease time>(sec), Renew-
Time=<renewtime>(sec).
The resource lease time received from the
DHCP server is displayed in [lease time] in
seconds. The renewal time is displayed in [re-
new time] in seconds.
Login to fileserver <file server name>
(<IPX|IPv4|IPv6>,<NDS|BINDERY>)
(In the print server mode)Login to the file serv-
er is in the NDS or BINDERY mode.
Memory allocate error. Data cannot be obtained.
Disconnect the USB cable, and then connect it.
Message Problem and solutions