Filter
Top Products
76
PROGRAMMING
[PROGRAMMING AN F-CODE RELAY GROUP]
This procedure is used to program an F-code relay
group box for relay broadcast of a received fax upon
receipt of an F-code relay request. Up to 10 boxes can
be programmed. An F-code (sub-address and
passcode) for reception of an F-code relay request
and the destinations to which the fax is to be relayed
are programmed in each box. To check the contents of
a programmed box, print the following list: "PRINT -
REPORT - SUB ADD SET LIST" (page 81).
To program an F-code relay group box, follow steps 1
through 6 on page 74 and then follow the steps below.
7
Select an unused box ("- - - - - -") with
the [ ] or [ ] key.
8
Press the [OK] key.
9
Enter a name for the F-code relay
group box (see "ENTERING
CHARACTERS" on page 82).
Up to 36 characters can be entered for the name. A
box name must be entered.
10
Press the [OK] key.
11
Enter a sub-address (maximum 20
digits) with the numeric keys.
See steps 3 and 4 on page 65.
12
Enter a passcode (maximum 20 digits)
with the numeric keys.
See steps 5 and 6 on page 65.
13
Enter the relay destinations. Enter full
fax numbers with the numeric keys
and/or press auto-dial keys (Rapid
keys, Speed Dial numbers, and group
keys) to select the destinations (page
20).
• To clear a mistake when entering a number with the
numeric keys, press the [C] key to clear one digit at a
time.
• A destination selected with a Rapid key, Speed Dial
number, or group key is indicated by an icon and a
number. To clear an entry, press the [C] key.
14
Press the [OK] key and then dial the
fax number of the next destination or
press an auto-dial key.
• After entering a full number
with the numeric keys, press
the [OK] key to complete the
entry. If you pressed an
auto-dial key in step 13, it is
not necessary to press the
[OK] key. You can
immediately press another
auto-dial key for the next
destination.
• Repeat steps 13 and 14 until
all destinations have been
entered.
15
Press the [START] key ( ) to end the
procedure.
GH
PQR
2-SIDED
COPY
SPECIAL FUNCTION
S.A. RELAY GRP
SBC CO.
——————
——————
[OK]:STORE START
GHI
OK
BACK
26 27 28 29 30
31 32 33 34 35
36 37 38 39 40
ABCDE
FGHIJ
KLMNO
ENTER GRP NAME
ABC
OK
WXYZ
26 27 28 29
31 32 33 34
ABC
FGH
ENTER RX STATION
:
GHI
OK
BACK
WXYZ
@.-
_
READ-END