Filter
Top Products
FreeFlow Process Manager Operator and Administrator Guide
2-99
Workflow Builder
Stock dimensions based on reference box The stock
dimensions are based on the resulting cell layout of the job type
and the size of the configured imposition reference box (PDF box)
on the first page of the input document only. If the reference box
is consistent size throughout the input document, unusual clipping
or unexpected border-gutter space may result.
Regional prioritization If you prioritize the automatic selection to
one of the standard named stock configurations, you may further
constrain the standard stock type used by regionality.
For each of the options, If no stock among the set is large enough
to encompass the layout area, a Custom type is created.
– If a standard stock type is identified, orientation is
dynamically configured to choose a stock orientation that
minimizes post-imposition waste areas.
– If the subsequent layout exceeds the size of an identifiable
standard stock type, a Custom stock type that
encompasses the layout area is created.
– If you choose not to prioritize among standard stock types,
a stock type that wholly encompasses the layout area is
created. This might equate dimensionally to a standard
named stock type.
Maximum size The maximum size for an automatic stock is 60” in
either direction.
Both Maximum N-up and Automatic stock selected If you
select both Maximum N-up and Automatic stock configurations,
the result is a Standard, non-Autofit job style output as the
maximum number of cells that can be fit onto a undefined area is
always equal to one.
Maximum N-Up limitations
• Cannot be used to automatically configure the printed stock.
• No support for Media Boxes.
• Bleed, Trim and Art boxes must be smaller than or equal to the
defined Crop box.
• Defined boxes in the input document are not carried over into
the imposed output document.