Filter
Top Products
Sample Solutions Using Dial Plan Configuration File Commands 121
In combination, the five lines in the internal table work with these two
lines in the Routes section of the dial plan.
DestinationRoute Create 1 Boston Low-cost Carrier
DestinationRoute Create 2 T1 Line to DEF Telephone Company
Explanation: Creates two routes, numbered 1 and 2, with the names
“Boston Low-cost Carrier” and “T1 Line to DEF Telephone Company.”
DestinationRouteEntry Create 1 1 *0001
DestinationRouteEntry Create 2 1 *0001
Explanation: In route 1, creates entry number 1, which defines
extension list *0001 (TLIM extensions) as the destination. Then creates, in
route 2, an entry that defines extension list *0002 (Digital Line Card
extensions) as the destination.
DestinationRouteOperation Create 1 1 1 stripLead 1
DestinationRouteOperation Create 2 1 1 stripLead 1
Explanation: Creates, in route 1, entry 1, operation number 1. This is a
stripLead operation, which removes the first digit from the dialed string,
then and passes the remaining digits to the carrier.
Customer Requirement 5. Assume that you want to transmit Calling
Line ID Presentation (CLIP) information on outgoing calls. You use internal
telephone extension numbers from 3000 to 3099. There is no DDI/DID, so
the T1 or E1 line has only a single number (555-555-1212). All incoming
calls are routed by default to the Auto Attendant.
Add these lines to the dial plan configuration file:
PreTranslator Create 1 CLIP Internal Ext to Single Number
Explanation: Create pretranslator table 1 called “CLIP Internal Ext to
Single Number.”
PreTranslatorEntry Create 1 1 3
Explanation: For pretranslator 1, create entry 1, which applies when the
first digit in the sequence is 3. (All internal telephone extensions begin
with the number 3.)
PreTranslatorOperation Create 1 1 1 replace 555 555 1212
Explanation: For pretranslator 1, entry 1, create operation 1, which
replaces the extension number with the string 555 555 1212.