Filter
Top Products
250 CHAPTER 3: DEVICE CONFIGURATION
4 Click Modify. The Modify Board dialog box appears.
5 Click the On Line check box.
6 Click OK.
7 In the T1/ISDN Board List, verify that the entry for this card in the Status
column changes from Offline to Online. You may need to wait a minute
or two, and then refresh your browser window to see this change.
Verifying the Change in Span Status
To verify that the Span status changes from Offline to Ready:
1 On the Digital Line Cards tab, select ISDN PRI Span List from the Select
Device Type list and click Apply.
2 Select the span from the list and click Modify.
3 Enable the On Line check box and click OK.
4 Verify that the word Ready appears in the ISDN PRI Span List line item
that corresponds to this span.
Configuring T1 Groups (ISDN PRI)
To configure a T1 ISDN PRI Group:
1 On the Digital Line Cards tab, select ISDN PRI Group List from the Select
Device Type list and click Apply.
2 From the ISDN PRI Group List, select PRI Group 1.
3 Click Modify. The Modify Group — T1 ISDN PRI dialog box appears.
4 To modify the name of the group, enter a new name in the Group Name
field. You can use alphanumeric characters, hyphens, and underscores.
The maximum name length is 30 characters.
5 To prohibit call transfers between trunk lines, select Restricted (the
default value) from the Trunk to Trunk drop-down list. Otherwise, select
Unrestricted.
6 Click the On Line check box.
7 Verify that 500 (the default) is in each of the four AutoExt text boxes.
8 Click OK.