Filter
Top Products
96 CHAPTER 2: DIAL PLAN
Configuring VTL
Passwords in the
Dial Plan
For each remote NBX system that controls hop-off by means of a VTL
password, you must configure that password into the VTL commands in
the local dial plan.
If you use site codes to access other NBX systems through VTL
connections, you can configure one set of VTL connections that permit
hop-off and are accessed one set of site codes. You can configure
another set of VTL connections that do not permit hop-off and are
accessed using a different set of site codes.
If you use unique extension ranges at each site, and therefore do not dial
a site code when placing VTL calls to users at those sites, you can still use
codes to access VTL connections that permit hop-off at the far end.
Figure 16
shows how to configure VTL passwords in a dial plan, using site
codes that permit hop-off and other site codes that do not. Each entry is
explained following the figure.