Filter
Top Products
Configuring and Managing E1 Digital Line Cards 239
Viewing DSP (Digital Signal Processor) Details
To view DSP (Digital Signal Processor) details:
1 Return to the Digital Line Cards tab.
2 From the Select Device Type list, select T1/ISDN Board List and click Apply.
3 Select the board you want and click Status.
4 In the Board Status dialog box, select a DSP from the DSP List and click
Details.
5 Click Close to close the DSP Status window.
Modifying IP Settings
for an E1 Card
You can modify the IP settings for an E1 card to meet changing
requirements.
The board must be on the same subnetwork as the Call Processor to
modify IP settings.
To modify the IP settings of a Digital Line Card:
1 Select NBX NetSet > Device Configuration > Digital Line Cards.
2 From the Select Device Type drop-down list, select T1/ISDN Board List.
3 Click Apply.
4 Select the board (ISDN PRI) for which you want to change the IP settings.
5 Click IP Settings.
If there is no IP Settings button in the dialog box, you have not yet
installed the IP licenses. You must install them before you can proceed.
6 To assign IP addresses automatically, enter the first address in the
First IP Address field. The system sequentially adds the remaining
addresses.
To assign IP addresses one at a time:
1 In the Digital Line Card IP Settings dialog box, click Assign Addresses
Individually.
2 Enter the desired IP addresses for the channels.
You must have IP licenses installed before you can enter addresses.
3 Enter the mask number for your site in the Common Subnet Mask field.
4 Enter IP address for the Common Default Gateway.
5 Click Apply.