Filter
Top Products
Configuring VPIM Parameters Using NBX NetSet 71
Configuring VPIM
Parameters Using
NBX NetSet
Using the NBX NetSet utility, you can configure several VPIM control
parameters, check the status of the VPIM queues, and obtain statistics on
recent VPIM activity.
VPIM Control
Parameters
To set the VPIM control parameters:
1 In the NBX NetSet - Main Menu window, click NBX Messaging.
2 Click the VPIM tab. Table 15
describes the fields.
Operations
Management
To manage outgoing voice mail messages, click Queue Management. The
Operations Management dialog box appears. See Table 16
.
Table 15 VPIM Tab Fields
Field Purpose
Max message size Controls the size of incoming messages from other
sites. If a message is larger than the specified
value, the NBX system rejects it. The default value
represents a voice mail message approximately 4
to 5 minutes in length.
Default: 3000 Kbytes
Time between send
attempts (minutes)
For outgoing messages, the NBX system may not
be able to contact the target system on the first
attempt. If so, the NBX system attempts to contact
the target system later. To change the time
between attempts, change this number.
Default: 15 minutes
Minimum: 1 minute
Maximum: 60 minutes
Max number of send attempts Specifies the number of times (Default: 4) that the
NBX system tries to connect to the target system.
After the specified number of send attempts, the
message is returned to the sender’s voice mailbox
with a notice that the message could not be sent.
Table 16 Operations Management Dialog Box Fields
Field Purpose
Operations status The status of the queue of outgoing voice mail messages.
Possible values: Starting, Ready, Processing, Stopped.