Filter
Top Products
5-2 Agilent B2200 User’s Guide, Edition 2
SCPI Command Reference
This chapter describes the following for Agilent B2200:
• SCPI commands available to control the B2200 via GPIB interface.
SCPI is a universal programming language for electronic test and measurement
instruments, and is based on IEEE 488.1 and IEEE 488.2.
SCPI commands are divided into two types: common commands and subsystem
commands.
Common commands are generally not measurement related, but are used to
manage status registers, data storage, and so on. Common commands are
defined by IEEE 488.2. All common commands begin with an asterisk, such as
*RST.
Subsystem commands are mostly measurement related and some are general
purpose. Subsystem commands have a hierarchical structure that uses a colon
between mnemonics (keywords), such as :DIAG:TEST:CARD:CLE.
Commands for the following subsystems are available for the B2200:
DIAGnostic commands for performing self-test.
ROUTe commands for signal routing.
SYSTem commands for controlling other functions that are not related
to instrument performance.
Commands are listed in alphabetical order in this chapter.
• Status reporting structure
These are IEEE 488.2 status structures (registers), which can be set or read by
the common commands.