Filter
Top Products
Agilent B2200 User’s Guide, Edition 2 3-7
Front Panel Operation
Operation
To Use Bias Mode
Bias mode cannot be set to ON when the ground mode is ON.
1. Change the bias-enabled output ports.
a. Press the
Shift key and the Port Function key.
b. Move the cursor to SET, then press the
Enter key.
c. Move the cursor to DISABLE, then press the
Enter key.
The LCD displays one of the bias-enabled output port numbers which can be
changed to the bias-disabled. Or if there is no bias-enabled output port, the
LCD displays Channel: No Channel. Press the arrow key to select the
output port to be changed to the bias-disabled, then press the
Enter key.
d. Move the cursor to ENABLE, then press the
Enter key.
The LCD displays one of the bias-disabled output port numbers which can
be changed to the bias-enabled. Or if there is no bias-disabled output ports,
the LCD displays Channel: No Channel. Press the arrow key to select
the output port to be changed to the bias-enabled, then press the
Enter key.
e. Repeat c and d until the bias-enabled port setup is completed. After that,
press the
Exit key more than once to display the status and setup conditions.
2. Press the
Bias Mode key to set the bias mode ON. Pressing the key again sets the
mode OFF.
3. Change the bias port (default setting: 10).
a. When the bias mode is ON, press the
Port Function key. The blink-cursor
appears on the first line of the LCD.
b. Press the right/left arrow key to move the cursor on the input port number
(01 to 14) that will be set to the input bias port.
c. Press the up/down key to display B, then press the
Enter key.