Filter
Top Products
Agilent B2200 User’s Guide, Edition 2 5-31
SCPI Command Reference
[:ROUTe]:BIAS:CHANnel:ENABle:CARD
Example OUTPUT @Agb2200;":ROUT:BIAS:CHAN:ENAB:CARD ALL"
OUTPUT @Agb2200;":ROUT:BIAS:CHAN:DIS (@10101)"
OUTPUT @Agb2200;":ROUT:BIAS:CHAN:DIS? (@10101,10102,10201)"
ENTER @Agb2200;A$
This example bias-disables the output port 1 on the card 1. In this example, A$ will
be 1,0,1.
[:ROUTe]:BIAS:CHANnel:ENABle:CARD
This command bias-enables the all output ports (channels) for the specified card.
When the Bias Mode is ON, the bias-enabled output ports that have not been
connected to any other input port are connected to the input Bias Port. This
command is available only for the specified card. At *RST, all cards are
bias-enabled. The bias mode is set by “[:ROUTe]:BIAS[:STATe]”.
Syntax [:ROUTe]:BIAS:CHANnel:ENABle:CARD card_number
Example OUTPUT @Agb2200;":ROUT:BIAS:CHAN:ENAB:CARD ALL"
[:ROUTe]:BIAS:CHANnel:ENABle[:LIST]
This command specifies the bias-enabled output ports (channels). When the Bias
Mode is ON, the bias-enabled output ports that have not been connected to any
other input port are connected to the input Bias Port. Then, the input Bias Port will
not be connected to the output ports that have been connected to any other input
port. At *RST, all channels are bias-enabled. The bias mode is set by
“[:ROUTe]:BIAS[:STATe]”.
The query returns whether the specified channels are bias-enabled or not.
Syntax [:ROUTe]:BIAS:CHANnel:ENABle[:LIST] (@channel_list)
[:ROUTe]:BIAS:CHANnel:ENABle[:LIST]? (@channel_list)
Parameter Explanation
card_number For Auto Config mode: 0 or ALL
For Normal Config mode: 1, 2, 3, 4, or ALL
Parameter Explanation
channel_list Channels to bias-enable or to check.
For channel_list, see “Switch Control” on page 4-5.