Datamax v1.1x Printer User Manual


 
Copyright © 2007 • MCL Technologies • All Rights Reserved
www.mcl-collection.com
Chapter 5 : Using Processes
5.2.3. Goto Label
General introduction The Goto command is an "unconditional" branch within the label
program. It will branch to the tags you set up in your program using
the Set Label process (see Section
5.2.6).
What is a label
(reference)
In this context, a label is a reference point in your program that can be
set to identify a specific position in the program, such as a certain line
in a process. Once a label reference is entered it always refers to the
same position in your program.
When a label is defined in a program, a direct jump to that location can
be made from anywhere within the program.
Goto Label To set a goto screen function, proceed as follows:
1 Add the process Goto Label to your label program
The Goto Label dialogue box is displayed.
Example In this example the program will jump to the location of the reference
point “Browse” that is set by the Set Label process.
October 2007 Page
138