Copyright © 2007 • MCL Technologies • All Rights Reserved
www.mcl-collection.com
Chapter 5 : Using Processes
5.2.6. Set Label
General introduction The Set Label process allows you to set a label (reference) in your label
program. A label can be up to 18 characters long.
These reference points can be used for jumping and branching within
your label program (See Section
5.2.3 - Goto Label).
Only uppercase alphabetic and numeric characters can be used in the
name of the label.
What is a label
(reference)
In this context, a label is a reference point in your program that can be
set to identify a specific position in the program, such as a certain line
in a process. Once a label reference is entered it always refers to the
same position in your program.
When a label is defined in a program, a direct jump to that location can
be made from anywhere within the program.
Set Label To set a label, proceed as follows:
1 Add the process Set Label to your label program
2 Type the name you want to identify this tag.
3 Click OK
Example In this example the program sets a reference point “Browse”. Using this
label you can jump to this point from anywhere in your program.
October 2007 Page
141