Filter
Top Products
Sprint SmartView Settings 91
Sprint SmartView Settings
Device Priority
If there are two or more devices within a technology type and Automatic is selected in the
Selection column, the devices within that technology type can be reordered to specify
priority. The first device within a technology type has the highest priority for that technology
type. Use the
Up and Down buttons, located below the Device List, to change the order in
which the devices are listed within their technology type.
Allow simultaneous connections
If this check box is selected, Sprint SmartView will allow you to establish more than one
connection at a time. (For example, you could be connected to both WiFi and mobile
broadband concurrently.)
If this check box is NOT selected, Sprint SmartView
will prompt you to disconnect before
allowing you to establish a second connection.
Note: Some VPN connections, such as those established with the Checkpoint VPN client, may be seen
as separate connections by the Sprint SmartView software. If the
Allow simultaneous
connections
check box is NOT selected, establishing such a VPN connection may trigger the
“Multiple Connections Not Allowed” error message.
Prompt before switching connections
When in automatic connection mode, the Sprint SmartView software can automatically
switch to a higher priority network if one becomes available. However, since the original
connection is shut down once the new connection is fully established, this has the potential
to disrupt any activity that was relying on the original connection.
If this check box is selected, Sprint SmartView
will prompt you for permission to switch
networks before it actually does so.
CDMA/WiMAX Dual-Mode Settings (Dual-Mode Devices Only)
These settings appear only if your Sprint Mobile Broadband device supports both CDMA
and WiMAX. Use these settings to specify when the Sprint SmartView software will switch
the device from WiMAX mode to CMDA mode. There are two options:
●
Automatic – Whenever you connect your device, the Sprint SmartView software will
switch the device to WiMAX mode. If you fail to connect via WiMAX, the software will
switch the device to CDMA mode.
●
CDMA Only – The Sprint SmartView software will leave the device in CDMA mode at
all times.
A third option,
WiMAX Only, is not available at this time.
Profiles
Click Profiles to open the Network Profiles window.