Filter
Top Products
94 Sprint SmartView Settings
Make a selection in the
Roam Guard drop-down list box to specify whether you would like
Sprint SmartView to display a warning message when you are about to connect to a roaming
network for which there may be additional roaming charges.
● Whe
n Always Ask is selected, Sprint SmartView will always display the warning message
when connecting to a roaming network.
● Whe
n Never Ask is selected, Sprint SmartView will never display the warning message.
Auto Connect when device is available
Select this check box if you want a connection to be automatically established each time you
connect your device to your computer. The feature behaves slightly differently when RAS is
selected (below) than it does when NDIS is selected. (See “Automatic Connection Upon Device
Attachment” on page 25 for more information on the device-based autoconnect feature.
Note: This check box is available only if the Allow Simultaneous Connections check box on the
Hardware settings tab is selected.
)
Connection Type
This group determines which software interface Sprint SmartView should use to communicate
with your device.
●
NDIS allows more efficient communication with devices that support it.
●
RAS is supported by more devices.
Note: Many devices support only one of these interfaces. If this is the case with your device, the interface
that your device supports will be selected by default and you will not be able to change the selection.