Filter
Top Products
Drive Error Codes 117
Drive Error Codes
Drive Monitor (from 2000h)
External Interfaces (from 2400h)
1C10h Drive Control did an eject during the power-on sequence.
1C11h A firmware upgrade cartridge has been loaded when a data cartridge was expected.
1C12h A firmware upgrade cartridge was expected but some other type of cartridge has
been inserted.
1C13h Failure due to drive temperature being out of acceptable range.
Code Description
2000h No error. Synonymous with GOOD status.
2001h Invalid parameter. The value of a parameter received with a Drive Monitor operation
falls outside its valid range.
Code Description
2400h Command holder full
2401h Bad command handle
2402h Empty command handle
2403h No tape loaded
2404h Already loaded
2405h In diagnostic mode
2406h Not in diagnostic mode
2407h Tried to write to write protected cartridge.
2408h Aborted an active command.
2409h Aborted a command before it became active.
240Ah Tried to abort a command that was not queued.
240Bh Invalid state requested of the EII State Manager.
240Ch The EII tried to process a firmware upgrade type that is not supported.
240Dh The EII state manager could not handle an abort request.
240Eh Tried to abort a command that was already being aborted.
Code Description