Filter
Top Products
120 Drive Error Codes
2C6Fh Received a PON or SCSI reset
2C70h A mode change (LVD/SE) occurred on the SCSI bus.
2C71h Gross error detected by the SCSI Macro
2C72h Illegal length record (ILI) — too long
2C73h Illegal length record (ILI) — too short
2C74h CRC error on read
2C75h The requested burst size was larger than the drive supports.
2C76h There was an invalid field in the mode parameter list for this
MODE SELECT
command
2C77h Unloading the tape
2C78h A parameter supplied by the internal requestor was out of range
2C79h The allocation length exceeded the permitted length.
2C7Ah Invalid (unsupported) page code
2C7Bh Invalid (unsupported) page code in parameter list
2C7Ch BOT encountered on space
2C7Dh EOT encountered on space
2C7Eh Blank Check, EOD was encountered. Returned by hiPerformPreExeChecks if
a space or read is attempted on a virgin tape.
2C7Fh Position lost. A temporary code for returning status after a write-behind error.
2C80h PCR error in the
LOG SELECT
command
2C81h The supplied Page Code is not a resetable page.
2C82h The supplied Page Code is not a writable page.
2C83h The reserved bit in the Log Page header has been set.
2C84h The
LOG SELECT
Page Length is incorrect.
2C85h There is an error with the Log Parameter Header.
2C86h
LOG SELECT
Parameter list length error.
2C87h The
LOG SENSE
Page Code is invalid.
2C88h The
LOG SENSE
PC Code is in error.
2C89h L
OG SELECT
: error in the parameter header
2C8Ah Restart the Logical Pipeline after a format error
2C8Eh The Buffer Manager has been interrupted with an error.
2C8Fh Check the cables. The Host Interface has exhausted all of the retries for a data phase.
2C90h
LOG SELECT
parameter list length error
Code Description