Filter
Top Products
Drive Error Codes 133
Drive Error Codes
742Bh A Set Tracking Offset command cannot be executed at this time, probably because a
servo calibration is in progress.
742Ch A DSP command to learn the VI offset is not allowed now because the tape is moving
or another task is in progress.
742Fh Debug ERROR code
7430h Sensors are in a state that indicate that the sensors or Callisto is not working cor-
rectly.
7431h Sensors are in a state that indicate that the sensors or Callisto is not working correctly
on a load.
7432h Sensors are in a state that indicate that the sensors or Callisto is not working correctly
on a grab.
7433h Sensors are in a state that indicate that the sensors or Callisto is not working correctly
on an ungrab.
7434h Sensors are in a state that indicate that the sensors or Callisto is not working correctly
on an unload.
7435h The RD sensor has stopped toggling, probably because the loader mechanism is
blocked or the motor is not working.
7436h It is unsafe to load the cartridge. A runaway condition of the FRM has been detected,
probably because the tape is broken
7437h Unexpected LP on a grab. One (and only one) of the LP sensors has been asserted at
the beginning of the grab.
7438h Unexpected LP at the start of a grab. One (and only one) of the LP sensors has been
asserted at the beginning of the grab. This is logged but not a failure.
7439h The write protect sensor does not match the expected state.
7440h Callisto Bus test error
7450h In transit after initialization
7451h Ungrab after initialization
7452h Unknown after initialization
7453h Timed out waiting to send a command to get DSP head-cleaning information
7454h Timed out waiting for DSP response with head-cleaning information
7455h Timed out waiting to set up DSP for a head-cleaning command
7456h Timed out waiting for DSP response to head-cleaning setup
7457h Timed out waiting for DSP to complete the head-cleaning command
7458h Head-cleaning engagement time-out
Error Description