Filter
Top Products
132 Drive Error Codes
740Fh Invalid task. The current task for the servo system is of an unknown type. This is most
likely caused by a firmware bug.
7410h A Load command is not allowed at this time.
7411h An Unload command is not allowed at this time.
7412h A shuttle tape command cannot be executed at this time.
7413h A Set Cartridge Type command cannot be executed at this time.
7414h A Set Mechanism Type command cannot be executed at this time.
7415h A Set Tension command cannot be executed at this time.
7416h A Set Speed command cannot be executed at this time.
7417h An Adjust Speed command cannot be executed at this time.
7418h A Set Position command cannot be executed at this time.
7419h The Cancel Set Position command cannot be executed at this time. Most likely
because there is no previous set position command active.
741Ah A Set Position and Speed command cannot be executed at this time.
741Bh A Servo Calibration command cannot be executed at this time.
741Ch An End of Tape Servo Calibration command cannot be executed at this time.
741Dh A Servo Initialization command cannot be executed at this time.
741Eh A Load Cartridge command cannot be executed at this time.
741Fh A Grab Leader Pin command cannot be executed at this time.
7420h A Load and Grab leader pin command cannot be executed at this time.
7421h An Ungrab Leader Pin command cannot be executed at this time.
7422h An Unload cartridge command cannot be executed at this time.
7423h A Thread command cannot be executed at this time.
7424h An Unthread command cannot be executed at this time.
7425h A Recover Tape command cannot be executed at this time.
7426h A Head Clean command cannot be executed at this time.
7427h A Power-on Calibration command cannot be executed at this time.
7428h A Set Notify command cannot be executed at this time.
7429h A Wait Until Event command cannot be executed at this time, probably because the
tape is not moving.
742Ah A Set Head Position command cannot be executed at this time, probably because a
servo calibration is in progress.
Error Description