Filter
Top Products
Drive Error Codes 135
Drive Error Codes
747Bh Time-out on completing the Clear DSP Fault log
747Ch Unable to send DSP Head Clean command
747Dh An abort command was requested while one is already in progress.
747Eh An abort command has timed-out while waiting for the tape to stop.
747Fh An Adjust Speed command was requested while one is already in progress.
7480h General load failure
7481h EP did not transition on a load, probably because no cartridge was present.
7482h CD did not transition on a load
7483h CG did not transition on a grab
7484h LP did not transition on a grab
7485h Too many retries to recover on a load or unload
7486h Cartridge not free to rotate when Cartridge Down
7487h The RD sensor stopped toggling while EP during a load.
7488h The RD sensor stopped toggling while IT during a load.
7489h The RD sensor stopped toggling while CD during a load.
748Ah The RD sensor stopped toggling while CD during a grab.
748Bh The RD sensor stopped toggling while LP during a grab.
748Dh FRM runaway. Too much rotation was detected in the cartridge before it was
threaded.
748Eh A grab was requested but the cartridge was not loaded
748Fh Sensors indicate that the grabber unexpectedly moved into a grab position during a
load operation.
7490h While parking the LP, the LM voltage was increased from .25V to .5V.
7491h While parking the LP, the LM voltage was increased from .5V to .75V
7492h While parking the LP, the LM voltage was increased from .75V to 1.0V
7493h While threading, the LM voltage was increased from .25V to .5V
7494h While threading, the LM voltage was increased from .5V to .75V
7495h While threading, the LM voltage was increased from .75V to 1.0V
74A0h General unload failure
74A1h EP did not transition while unloading
74A2h CD did not transition while unloading
74A3h CG did not transition while ungrabbing
74A4h LP did not transition while ungrabbing
Error Description