Filter
Top Products
Drive Error Codes 131
Drive Error Codes
System Architecture (from 6400h)
Tight Integ (from 6800h)
Trace Logger (from 6C00h)
Mechanical Interface (from 7400h)
Error Description
6401h Formatter ASIC revision check failed. The ASIC is not a Gen 1 Formatter ASIC.
6402h The processor idle time is less than 30%.
Error Description
6801h The Cmicro error handler function has been called (cm_ErrorHandler).
6802h An implicit signal consumption has occurred.
Error Description
6C00h TraceLogger initialization failed
Error Description
7400h No error
7401h Aborted command
7402h Unsupported command
7403h Wrong number of parameters
7404h Invalid parameter
7405h This command is already in progress.
7406h This command is not allowed now.
7407h Command processing error
7409h The command is obsolete.
740Ah Incomplete initialization of the mechanism
740Bh There was a timing fault in the servo interrupt.
740Ch The mechanism type (SensorRev) specified in the mechanism EEPROM is either
obsolete or unsupported.
740Dh Obsolete command 300C
740Eh Obsolete command 300D