Filter
Top Products
122 Drive Error Codes
Logical Formatter (from 3000h)
2CABh MAM attribute header truncated. The specified parameter list length has caused an
attribute header to be truncated.
2CACh Reserved field set in a MAM attribute header
2CADh MAM attribute IDs were not ascending order.
2CAEh The MAM attribute header specified an unsupported attribute value.
2CAFh A MAM attribute ID is unsupported.
2CB0h A MAM attribute ID is in an incorrect format.
2CB1h The MAM attribute header specifies an incorrect length for this attribute
2Cb2h The host attribute area in MAM is full.
2CB3h A
WRITE ATTRIBUTE
command attempted to delete a non-existent attribute.
2CB4h An invalid MAM service action was requested.
2CB5h A
READ ATTRIBUTE
command failed because the Host Attribute area was not valid.
2CB6h There is an invalid field in the MAM attribute data.
2CB7h Failure prediction threshold exceeded. A Tape Alert flag has been set and the next
SCSI command needs to be check conditioned.
2CB8h GWIF idle error, cause unknown. This will never be returned to the host.
2CB9h GWIF idle, read error. This will never be returned to the host.
2CBAh GWIF idle, write error. This will never be returned to the host.
2CBBh MAM is accessible but the cartridge is in the load “hold” position. U
NIT ATTENTION
is
generated.
2CBCh MAM is accessible but the cartridge is in the load “hold” position. N
OT READY
is gen-
erated.
Code Description
3000h No error. Synonymous with
GOOD
status.
3001h Operation of the Logical Formatter has been aborted.
3002h Busy. A Logical Formatter process has received a operation request while in a tran-
sient state.
3003h Invalid parameter.
3004h Unsupported operation. A Logical Formatter process received an operation request
while in a mode that does not support that operation.
3010h Power-on or reset failure
Code Description