Filter
Top Products
138 Drive Error Codes
7511h Multiple write faults
7512h Last write fault
7600h Set Speed command invalid parameter
7601h Adjust Speed command invalid parameter
7602h Set Position command invalid parameter
7603h Set Head Position command invalid parameter
7604h Set Head Table command invalid parameter
7605h DSP Statistics command invalid parameter
7606h Get Servo Fault command invalid parameter
7607h Set Tracking Offset command invalid parameter
7608h Set Notify command invalid parameter
7609h Clear Notify command null handle
760Ah ATS Diagnostics command invalid parameter
760Bh Hall Calibrate command invalid parameter
760Ch Radius Calibrate command invalid parameter
760Dh Wait Until Event command invalid parameter
760Eh Convert LPOS command invalid parameter
760Fh Shuttle command invalid parameter
7610h Get DSP fault log invalid parameter
7620h Set speed operation timed out during a recover tape command.
7621h Timed out waiting for the pin sensors to indicate almost parked.
7622h Timed out waiting for the pin sensors to indicate fully parked.
7623h An unthread timed out waiting for the full leader pin seating tension to be estab-
lished.
7624h Cycling the pull-in tension did not achieve pin-park.
7625h Rethreading and then unthreading again did not get the leader pin parked.
7626h Timed out during the rethread/re-unthread recovery while waiting for almost parked.
7627h All recovery algorithms have been exhausted and still unable to park leader pin.
7628h Rethread recovery operation timed out waiting for the tape to come to a stop.
7629h Rethreading timed out while waiting for the tape to reach the required position.
762Ah Deslacking process did not complete., probably because the back reel motor failed to
rotate.
762Bh The leader pin was parked as indicated by both LP sensors but then came unparked.
Error Description