Filter
Top Products
140 Drive Error Codes
7686h The thread operation is being retried because the pin detect sensor indicates parked
when not parked.
7687h The threading recovery could not get the tape stopped in a reasonable time period.
7688h Timed out waiting for a regrab to complete before threading.
7689h Timed out trying to read the media manufacturer’s information.
768Ah A faulty LP sensor has made it necessary to detect pin parking via FRM stall.
768Bh Attempt to park failed. An LP sensor was most likely asserted when it should not have
been.
768Ch A VI cal was necessary to recover a DSP seek command failure. (This is a recovery
algorithm.)
76EBh The drive has cooled and the cooling fan has been turned off.
76ECh The drive is getting too hot and the cooling fan has been turned on.
76EDh The drive has cooled; resuming normal tape speeds.
76EEh The drive is getting too hot; tape speed is now being reduced to a minimum.
76EFh ASIC temperatures are too high. Operations must stop and the cartridge must be
ejected.
76F0h The address into the main DRAM buffer must be on an even byte boundary.
76F1h The address into the main DRAM buffer is outside the range allowed for the servo
system to use.
76F2h The specified mode is not valid.
76F3h The specified scope channel bit width is not supported.
76F4h The specified scope trigger position is too large compared to the specified number of
data packets in the trace.
76F5h The length of the buffer must be larger than zero and an even number.
76F6h The specified source number is not valid.
76F7h The specified scope buffer format parameter is not valid.
76F8h A reel driver calibration factor is out of range.
76F9 A reel driver calibration factor for static torque loss is out of range.
76Fa A reel driver calibration factor for dynamic torque loss is out of range.
76FB The temperature is above the maximum limit.
76FC The temperature is below the minimum limit.
76FD EEPROM values are unavailable. The default servo tuning values are being used
instead.
76FEh Previous fault conditions have made it unsafe to thread this cartridge.
Error Description