Filter
Top Products
Drive Error Codes 121
Drive Error Codes
2C91h This error code will never be seen.
2C92h The failure prediction threshold has been exceeded. This error code is sent when a
CHECK CONDITION
is generated for a CDB as a result of the Test flag being set in the
Information Exceptions Mode page.
2C93h Reset after GE. Triggers the power-on self-test UA 2900 after Generation 1 SCSI
ASIC GE has been detected.
2C94h Return
GOOD
status. Used to force
GOOD
status to be returned.
2C95h There is a firmware bug in the handling of an
INQUIRY
page.
2C96h There is a firmware bug in the execution of the Prevent/Allow Medium
Removal command.
2C97h There is a firmware bug in the parsing of a Mode page.
2C98h An attempt was made to write data or filemarks inside EW-EOM.
2C99h Firmware incorrectly programmed the SCSI macro.
2C9Ah An unsupported LUN was specified in the SCSI Identify message.
2C9Bh Aborting a previous command
2C9Ch Aborting and no disconnect. A command was rejected that could not be queued
while an abort was in progress.
2C9Dh The host interface has exhausted all of the retries for a command phase.
2C9Eh Parameter not supported. A request for an invalid page code has been sent.
2C9Fh Buffer offset good. This is used internally by the Read Write Buffer code and should
never be reported to the host.
2CA0h Operation in progress. Reported when an Immediate command is executing and a
subsequent command is received.
2CA1h Illegal length record (ILI) — too long, and there is an EOR in FIFO. This occurs when a
record is long by less than the FIFO length.
2CA2h Illegal length record (ILI) — too short with bad CRC
2CA3h Illegal length record (ILI) — too long with bad CRC
2CA4h LUN not configured. The drive is the process of becoming ready.
2CA5h ILI long has been detected but a read error was encountered during the residue flush.
2CA6h An init command is required; a tape has been loaded but not threaded.
2CA7h ILI long has been detected but flushing the residue timed out.
2CA8h Generation 1 drives only: The CD-ROM El Torito identifier is corrupt.
2CA9h The Gen 1 Formatter ASIC is not supported any more.
2CAAh The Generation 1 SCSI ASIC is an invalid revision.
Code Description