Filter
Top Products
Drive Error Codes 139
Drive Error Codes
762Ch The tape has been recovered and leader pin parked but the original operation failed
and was abandoned.
762Dh Rethreading timed out while waiting for the tape to reach the required position.
762Eh Rethread recovery operation timed out waiting for the tape to come to a stop.
762Fh A special unthreading recovery operation was needed to un-jam the leader block.
7630h An iteration of the special unthreading recovery operation did not succeed.
7631h The stop tape operation took longer than expected.
7632h An attempt was made to stop the tape while still too far away from the specified posi-
tion.
7633h An abort command was issued and stopped the tape motion operation that was
already in progress.
7634h The tape thickness is too great to be handled properly by the servo system.
7635h An ATS speed change operation (AdjustSpeed) timed out waiting for tape to reach
target speed.
7636h An ATS speed change operation (AdjustSpeed) was attempted while the tape was not
moving.
7637h While trying to park the pin, LP2 was seen, but LP1 was not seen after rotating the
grabber CCW.
7638h Threading timed out while waiting for the half moon to seat onto the back reel.
7639h Tape motion apparently stopped while waiting for head positioning to complete.
763Ah Unthread timed out during the initial rewind of tape back into the cartridge.
763Bh Timed out during an operation to set tape position and speed.
763Ch Timed out during an operation to set the tape position.
763Dh Timed out during a RecoverTape operation.
763Eh The front reel did not rotate during the tape slack removal process.
7680h The DSP was commanded to re-lock onto servo code. (This is a recovery algorithm.)
7681h A retry was necessary on a DSP seek command. (This is a recovery algorithm.)
7682h A retry was necessary on a DSP VI-sensor cal command. (This is a recovery algo-
rithm.)
7683h A retry was necessary on a DSP azimuth cal command. (This is a recovery algorithm.)
7684h A retry was necessary on a DSP command to learn the VI-offset. (This is a recovery
algorithm.)
7685h Unable to thread. An ungrab/regrab/rethread recovery process will now be
attempted.
Error Description