Filter
Top Products
GVRP Commands
Intel® Blade Server Ethernet Switch Modules SBCEGBESW1 and SBCEGBESW10 CLI Guide 105
• timer_value — Timer values in milliseconds in multiples of 10. (Range: 10-
2147483640)
Default Configuration
Following are the default timer values:
• Join timer — 200 milliseconds
• Leave timer — 600 milliseconds
• Leavall timer — 10000 milliseconds
Command Mode
Interface Configuration (Ethernet, port-channel) mode
User Guidelines
The following relationship must be maintained between the timers:
Leave time must be greater than or equal to three times the join time.
Leave-all time must be greater than the leave time.
Set the same GARP timer values on all Layer 2-connected devices. If the GARP timers
are set differently on Layer 2-connected devices, the GARP application will not operate
successfully.
Example
The following example sets the leave timer for Ethernet port 6 to 900 milliseconds.
gvrp vlan-creation-forbid
The gvrp vlan-creation-forbid Interface Configuration (Ethernet, port-channel) mode
command disables dynamic VLAN creation or modification. To enable dynamic VLAN
creation or modification, use the
no form of this command.
Syntax
gvrp vlan-creation-forbid
no gvrp vlan-creation-forbid
Console(config)#
interface ethernet
ext.6
Console(config-if)#
garp timer leave
900