Filter
Top Products
Address Table Commands
Intel® Blade Server Ethernet Switch Modules SBCEGBESW1 and SBCEGBESW10 CLI Guide 23
bridge multicast address
The bridge multicast address Interface Configuration (VLAN) mode command registers a
MAC-layer multicast address in the bridge table and statically adds ports to the group. To
unregister the MAC address, use the no form of this command.
Syntax
bridge multicast address {mac-multicast-address | ip-multicast-address}
bridge multicast address {mac-multicast-address | ip-multicast-address} [add | remove]
{ethernet interface-list | port-channel port-channel-number-list}
no bridge multicast address {mac-multicast-address | ip-multicast-address}
Parameters
• add — Adds ports to the group. If no option is specified, this is the default option.
• remove — Removes ports from the group.
• mac-multicast-address — A valid MAC multicast address.
• ip- multicast-address — A valid IP multicast address.
• interface-list — Separate nonconsecutive Ethernet ports with a comma and no spaces;
a hyphen is used to designate a range of ports.
• port-channel-number-list — Separate nonconsecutive port-channels with a comma
and no spaces; a hyphen is used to designate a range of ports.
Default Configuration
No multicast addresses are defined.
Command Mode
Interface Configuration (VLAN) mode
User Guidelines
If the command is executed without add or remove, the command only registers the group
in the bridge database.
Static multicast addresses can only be defined on static VLANs.