Filter
Top Products
Intel® Blade Server Ethernet Switch Modules SBCEGBESW1 and SBCEGBESW10 CLI Guide 215
19 RADIUS Commands
radius-server host
The radius-server host Global Configuration mode command specifies a RADIUS server
host. To delete the specified RADIUS host, use the
no form of this command.
Syntax
radius-server host {ip-address | hostname} [auth-port auth-port-number] [timeout
timeout] [retransmit retries] [deadtime deadtime] [key key-string] [source source]
[
priority priority] [usage type]
no radius-server host {ip-address | hostname}
Parameters
• ip-address — IP address of the RADIUS server host.
• hostname — Hostname of the RADIUS server host. (Range: 1-158 characters)
• auth-port-number — Port number for authentication requests. The host is not used for
authentication if the port number is set to 0. (Range: 0-65535)
• timeout — Specifies the timeout value in seconds. (Range: 1-30)
• retries — Specifies the retransmit value. (Range: 1-10)
• deadtime — Length of time in minutes during which a RADIUS server is skipped
over by transaction requests. (Range: 0-2000)
• key-string — Specifies the authentication and encryption key for all RADIUS
communications between the device and the RADIUS server. This key must match
the encryption used on the RADIUS daemon. To specify an empty string, enter "".
(Range: 0-128 characters)
• source — Specifies the source IP address to use for communication. 0.0.0.0 is
interpreted as request to use the IP address of the outgoing IP interface.
• priority — Determines the order in which servers are used, where 0 has the highest
priority. (Range: 0-65535)
• type — Specifies the usage type of the server. Possible values: login, dot.1x, wireless
or
all.
Default Configuration
No RADIUS server host is specified.