Filter
Top Products
Clock Commands
64 Intel® Blade Server Ethernet Switch Modules SBCEGBESW1 and SBCEGBESW10 CLI Guide
Default Configuration
Polling is disabled.
Command Mode
Global Configuration mode
User Guidelines
Polling time is determined by the sntp client poll timer Global Configuration mode
command.
Example
The following example enables polling for SNTP predefined unicast clients.
sntp server
The sntp server Global Configuration mode command configures the device to use the
Simple Network Time Protocol (SNTP) to request and accept SNTP traffic from a
specified server. To remove a server from the list of SNTP servers, use the
no form of this
command.
Syntax
sntp server {ip-address | hostname}[poll] [key keyid]
no sntp server host
Parameters
• ip-address — IP address of the server.
• hostname — Hostname of the server. (Range: 1-158 characters)
• poll — Enable polling.
• keyid — Authentication key to use when sending packets to this peer. (Range:1-
4294967295)
Default Configuration
No servers are defined.
Console(config)#
sntp unicast client poll